March 2011 Show & Tell Pictures

Mark Ayers


Mark made this Carub Bowl as a project with Stephen.

This Toothpick Holder is made from Olive and Bubenga and finished in Oil. It was done in Stephen's turning workshop.
3/5/2011 Click on image to see closeup.

Dave Blackburn


This small Box is made from Maple Burl, Purple Heart, Ash, Oak, Mahogany, and Libnum Vitae and finished in satin urethane.

The Labarinth Lift Top Box is made from Walnut, Buckeye and Ebony. The finish is mineral oil.
3/5/2011 Click on image to see closeup.

Jack Budny


Jack made this Infeed/Outfeed support for his table saw, jointer, planer, drill press and band saw. It is to handle long stock and was made from scrap wood. Note that it is NOT a tripod, which would tilt!
3/5/2011 Click on image to see closeup.

Stephen Case-Pall


This Pokal Goblet was turned from Walnut and finished with oil on the lathe.

A Turned Box
3/5/2011 Click on image to see closeup.

Dan Gallo


Gentleman's Box By Dan Gallo
This scroll sawn box is made from Spanish cedar. The finish is a 50/50 mixture of boiled linseed oil and mineral spirits. The topcoat is Deft semi gloss spray lacquer.
The inside bottom is flocked with wine colored flocking. The pattern is by John A. Nelson.
3/5/2011 Click on image to see closeup.

Arlen Handberg


A Table Saw Fence Storage Box for pencils, calculator, etc. It is made from Maple and finished in lacquer.
3/5/2011 Click on image to see closeup.

Wayne Jackson


Wayne made this Tea Box for storing tea... It is made from Baltic Birch and Pine and is unfinished.
3/5/2011 Click on image to see closeup.

Bob Pollard


This Treasure Chest is made from Walnut, Beach and Curly Maple and is finished in poly. Apologies from the photographer on this one.
3/5/2011 Click on image to see closeup.


Marble Climber toy is a kinetic machine using a crank and cams. It is made from Mahogany, Curly Maple, Buckeye Maple, Olive, Walnut and Oak and is finished in poly.
3/5/2011 Click on image to see closeup.

Dave Studley


This is a piece of Dave's newly started Platform Bed made from Poplar and Birch and is finished in General Poly.
3/5/2011 Click on image to see closeup.

Mark Tsujihara


This os a Shooting Board made from Phenolic faced plywood, Maple (fence), and White Oak (stop).
3/5/2011 Click on image to see closeup.

Dan Waingrow


Heart Puzzle

Pivot Lid Heart Box... again apologies for the poor picture.
3/5/2011 Click on image to see closeup.

Gene West


Gene's Walking Robot toy is made from various hardwoods and is finished in acrylic. With a little push, the robot will walk down a ramp.

This Jack-in-the-Box is cam operated. It is made from Baltic Birch and finished in acrylic.
3/5/2011 Click on image to see closeup.